+#~ msgid ""
+#~ "Your DCP has fewer than 6 audio channels. This may cause problems on "
+#~ "some projectors."
+#~ msgstr ""
+#~ "Din DCP har färre än 6 ljudkanaler. Detta kan orsaka problem på några "
+#~ "projektorer."
+
+#~ msgid ""
+#~ "However, setting your DCP frame rate to 24 or 48 will cause a significant "
+#~ "slowdown of your content, and SMPTE DCPs are not supported by all "
+#~ "projectors."
+#~ msgstr ""
+#~ "Att sätta DCP bildhastigheten till 24 eller 48 kommer att medföra en "
+#~ "betydlig hastighetssänkning av innehållet, och SMPTE DCP:er stöds inte av "
+#~ "alla projektorer."
+
+#~ msgid ""
+#~ "However, setting your DCP frame rate to 24 or 48 will cause a significant "
+#~ "speed-up of your content, and SMPTE DCPs are not supported by all "
+#~ "projectors."
+#~ msgstr ""
+#~ "Att sätta DCP bildhastigheten till 24 eller 48 kommer att medföra en "
+#~ "betydlig hastighetsökning av innehållet, och SMPTE DCP:er stöds inte av "
+#~ "alla projektorer."
+
+#~ msgid ""
+#~ "You are set up for an Interop DCP at a frame rate which is not officially "
+#~ "supported. You are advised either to change the frame rate of your DCP "
+#~ "or to make a SMPTE DCP instead (although SMPTE DCPs are not supported by "
+#~ "all projectors)."
+#~ msgstr ""
+#~ "Du har valt Interop DCP med en bildhastighet som inte har officiellt "
+#~ "stöd. Du uppmanas att skapa en SMPTE DCP istället (men SMPTE DCP:er stöds "
+#~ "inte av alla projektorer)."
+
+#~ msgid ""
+#~ "You are set up for an Interop DCP at a frame rate which is not officially "
+#~ "supported. You are advised either to change the frame rate of your DCP "
+#~ "or to make a SMPTE DCP instead."
+#~ msgstr ""
+#~ "Du har valt Interop DCP med en bildhastighet som inte har officiellt "
+#~ "stöd. Du uppmanas att antingen ändra bildhastigheten eller skapa en SMPTE "
+#~ "DCP istället."
+
+#, fuzzy
+#~ msgid "Could not write whole file"
+#~ msgstr "Kunde inte skriva till fjärrfil (%1)"
+
+#, fuzzy
+#~ msgid "Could not decode image file %1 (%2)"
+#~ msgstr "Kunde inte avkoda bildfil (%1)"
+
+#, fuzzy
+#~ msgid "it overlaps other subtitle content; remove the other content."
+#~ msgstr "Det finns annan undertext som överlappar denna DCP; ta bort den."
+
+#~ msgid ""
+#~ "The DCP %1 was being referred to by this film. This not now possible "
+#~ "because the reel sizes in the film no longer agree with those in the "
+#~ "imported DCP.\n"
+#~ "\n"
+#~ "Setting the 'Reel type' to 'split by video content' will probably help.\n"
+#~ "\n"
+#~ "After doing that you would need to re-tick the appropriate 'refer to "
+#~ "existing DCP' checkboxes."
+#~ msgstr ""
+#~ "DCP %1 refererades till av denna film. Detta är inte möjligt nu eftersom "
+#~ "storleken på rullarna i filmen inte längre stämmer med dom i den "
+#~ "importerade DCP:n.\n"
+#~ "\n"
+#~ "Det hjälper troligen att sätta 'Typ av rulle' till 'dela upp baserat på "
+#~ "videoinnehåll'.\n"
+#~ "\n"
+#~ "Efter denna manöver behöver du också fylla i rätt checkbox under "
+#~ "'Referera till existerande DCP'."
+
+#~ msgid "Could not find pixel format for video."
+#~ msgstr "Kunde inte hitta information om pixel-formatet för videon."
+
+#~ msgid "2.35"
+#~ msgstr "2,35"
+
+#~ msgid "16:9"
+#~ msgstr "16:9"
+
+#~ msgid "4:3"
+#~ msgstr "4:3"
+
+#~ msgid ""
+#~ "Your DCP frame rate (%1 fps) may cause problems in a few (mostly older) "
+#~ "projectors. Use 24 or 48 frames per second to be on the safe side."
+#~ msgstr ""
+#~ "Din DCP-bildhastighet (%1 bps) kan orsaka problem på några (mest äldre) "
+#~ "projektorer. Använd 24 eller 48 bilder per sekund för att vara säker."
+
+#~ msgid "Finding length and subtitles"
+#~ msgstr "Söker längd och undertexter"
+
+#~ msgid "Encoding picture and sound"
+#~ msgstr "Kodar bild och ljud"
+
+#~ msgid "remaining"
+#~ msgstr "återstående tid"
+
+#~ msgid ""
+#~ "The KDM does not decrypt the DCP. Perhaps it is targeted at the wrong "
+#~ "CPL."
+#~ msgstr "KDM:en dekrypterar inte DCP:n. Kanske är den gjord för fel CPL."
+